top of page

2023 Jeep Gladiator

$138,995

** Consignment **

392 HEMI | AMW 505

Highlights

  • AMW 505 | 392 Engine Conversion Package

  • Heavy-Duty Dana® 44 Front Axle

  • Heavy-Duty Dana® 44 Rear Axle

  • Hemi Tuned Long Arm Suspension Package

  • Steering Gearbox | Cylinder Assist

  • Command-Trac® Part-Time 4WD System

  • Heavy-Duty 4-Wheel Anti-Lock Disc Brakes

  • 17-Inch x 7.5-Inch KMC KM724 Black Wheels

CLICK TO VIEW THE STICKER

2023 AMW 505 | 392 Engine Conversion Package 

  • 6.4L SRT8 392 Mopar® Crate Engine | Non-MDS

  • 8HP75 Tuned Heavy Duty Transmission

  • HEMI® Oil Pan Deep Steel Rear Sump

  • HEMI® 3.0” Exhaust Manifold Kit: Heat Shields | Hardware

  • Complete Exhaust System | Stainless Steel | Mandrel Bent 3.5” Tubing Catalytic Converters | Muffler | Resonator

  • Alternator 220 Amp High Output

  • Power Steering High Flow Pump | Reservoir | Steering Cooler 

  • Air Conditioning Compressor | Mandrel Bent Air Conditioning Line Kit

  • Engine Oil Filter Relocation | Engine Oil Cooler Kit

  • Transmission Eight Speed Heavy Duty Automatic | Billet 6061 Heater Delete 185°C Thermostat |Fluid Supply Line Kit

  • Transmission Control Module | AMW True-Shift Manual Shift Mode 

  • Security Gateway Bypass Module | Steering Wheel Controlled | Instrument Panel Displayed | Integrated Body Control Calibration Tool

  • Three Year Engine Conversion Warranty | One Year Labor by Approved Licensed Service Center


Hemi Tuned Long Arm Suspension Package

  • Hemi Tuned Dual Rate Coil Springs

  • Hemi Tuned Piggyback 3.3 Fast Adjust Shocks by Falcon

  • SpeedBump Front & Rear Bump Stop Kit 

  • Front & Rear Upper Adjustable Long Control Arms

  • Front & Rear Lower Adjustable Long Control Arms

  • Front & Rear Forged Adjustable Track Bars

  • Rear Heavy-Duty Sway Bar 


Steering Gearbox | Cylinder Assist  

  • Ported Cast Iron Gearbox | Ratio: 16:1

  • Track Bar Reinforcement Bracket: Frame Side

  • Cylinder Assist Ram: Stroke: 6.75 Bore: 1.75”  

  • Forged Tie Rod Assembly: 1½-Ton

  • Forged Drag Link Assembly: 1½-Ton 

  • Tie Rod Ram Clamp: 1½-Ton | Billet


Wheel & Tire Package

  • KM724 Impact Wheel: 17" | Pattern: 8 on 6.5”  

  • Nitto Trail Grappler M/T: 37x12.50R17LT 

  • Mopar Tire Pressure Monitoring Sensor: TPMS

  • Spline Drive Lug Nuts: 14x1.50mm | Black

  

  Rubicon Transfer Case 

  • Low Range Ratio: 4.1:1

  • Input Gear: 35-Spline 

  • Rear Yoke: 1350CV

bottom of page