Home > Electrical > Wiring >

JL JT OEM Locker Correction Harness
JL JT OEM Locker Correction Harness

Our Price: $179.00

Stock Status:In Stock

Availability:: Usually Ships in 24 to 48 Hours
Product Code: Z_LKR_OEM


Developed in a partnership with Z Automotive Technologies! The locker sensor in Wrangler JL and Gladiator Rubicons have started to become problematic.  When they fail, it usually starts out like a blinking locker lamp on the dash, which then ends up in a “service axle locker” message.  Once the locker system is in this fault state, the lockers will no longer engage.

The repair would normally be to replace the sensor, but the part is not available separately.  The next best thing would be to replace the locker assembly, but that’s not available either.  The current solution is to replace the entire axle assembly, but due to the commonality of this problem, they are on national back-order.

The Z-Locker-OEM solves this problem.  Bypassing the problematic sensor, it allows the locker to operate without the position sensor yet provides the proper feedback to the Jeep’s computers to keep the system operational without any errors or warnings.  You get fully functioning lockers with no side effects from using the Z-Locker-OEM.

Installation is simple; unplug the locker, plug the Z-Locker-OEM in between the axle and Jeep harness.  This can be done in seconds with no tools.  Will not harm the Jeep’s computers – it uses the same signaling that it expects from the sensor.  Connectors are the same ones used by Jeep and are watertight.

Package contains one Z-Locker-OEM, to service one failed axle locker.

Share your knowledge of this product. Be the first to write a review »