Home > Wrangler JL (2018 - ) >


Our Price: $329.00

Quantity in Stock:20

Availability:: Available for download within 24 hours
Product Code: JL-TAZER

  • Simple, plug-in installation – 2 parts: a bypass module plugged in above the OBD2 connector and the Tazer JL itself which plugs into the OBD2 connector.

    There are two sets of features – those that program the vehicle to accommodate modifications made to the Jeep, and the “live” features that run only when the Tazer JL remains plugged in.

    These are all accessed using the dash display, using steering wheel buttons to navigate the menus.

    Settings – once the Tazer is “married” to the Jeep, the following menus can be accessed. Unmarrying the Tazer JL will bring the settings back to stock.

    Perf menu:

  • Adjust for alternate tire sizes up to 41″
  • Adjust for alternate axle gear ratios
  • Adjust for an alternate transfer case LO range ratio
  • TPMS menu:

  • Disable TPMS system if desired
  • Change front/rear TPMS warning PSI limit
  • Radio menu:

  • Disable Backup camera
  • Enable Cargo/front/uncercarriage Camera input
  • Enable CD audio input
  • Disable TravelLink (weather warnings included)
  • Lighting Menu:

  • Change DRL region (type)
  • Change DRL location
  • Disable DRL Dropout
  • Enable Fog lamp output
  • Disable Fog lamp dropout
  • Disable Halo’s
  • Set LED 3rd brake light type
  • Set LED tail lamp type
  • Set LED front turn signal type
  • Set Trailer Tow output for use with Mopar kit
  • Other menu:

  • Disable/Enable Electronic sway bar – for axle swaps or to run disconnected at any speed or drive mode
  • Disable/Enable Front Axle Disconnect
  • Disable/Enable Front and Rear Lockers
  • Enable Aux switch settings on the radio
  • Enable Blind spot detection (sensors required)
  • Change cluster splash screen to Wrangler/Sahara/Rubicon
  • Live features – these run only while the tazer is plugged in:

    Light shows: Can be accessed from the key fob or from the on-screen menu. 6 pre-set light shows and 3 make-your-own shows included. Set from the factory to only operate when parked, but can be unlocked for off-road and emergency personnel use.

    Disable Navigation in-motion lockout – enter addresses while the vehicle is moving

    Disable camera lockout – use the backup camera and/or added cargo/front/undercarriage camera at any speed for any length of time

    Auto Traction Kill – can be set to turn off traction control upon start-up

    Auto StopStart Disable – can be set to disable AutoStopStart upon vehicle start-up

    0-30 and 0-60 timers

    Cooldown mode – run engine fans when Jeep is off, to aid in cooldown

    Winch mode – raise engine idle to 2000 RPM while winching or jumping another vehicle

    Clear Check engine light

    Free USB updates

Share your knowledge of this product. Be the first to write a review »